Owners Manual
Table Of Contents
- Latitude 7220 Rugged Extreme Tablet 5G Service Manual
- Contents
- Working on your tablet
- Removing and installing components
- Recommended tools
- Screw list
- Major components of your system
- Batteries
- Subscriber Identification Module (SIM) card
- Stylus
- Display assembly
- Function keys
- SSD Heat-sink
- System fan
- Solid-state drive
- WLAN card
- WWAN card
- Microphone
- Front camera
- Coin-cell battery
- System board
- Rear Camera
- Micro serial port and power connector port
- Docking Board
- Smart card reader and wireless passthrough daughterboard
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Slide the stylus upward using the groove on the stylus pen.
NOTE: Avoid pulling the stylus with the stretchable thread.
2. Loosen the knot and slip the stylus through the hole to remove the tether from the chassis.
Installing the stylus
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the stylus and provides a visual representation of the installation procedure.
18
Removing and installing components