Owners Manual
Table Of Contents
- Latitude 7220 Rugged Extreme Tablet 5G Service Manual
- Contents
- Working on your tablet
- Removing and installing components
- Recommended tools
- Screw list
- Major components of your system
- Batteries
- Subscriber Identification Module (SIM) card
- Stylus
- Display assembly
- Function keys
- SSD Heat-sink
- System fan
- Solid-state drive
- WLAN card
- WWAN card
- Microphone
- Front camera
- Coin-cell battery
- System board
- Rear Camera
- Micro serial port and power connector port
- Docking Board
- Smart card reader and wireless passthrough daughterboard
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Unroute the cable from the routing guide on the system fan.
2. Disconnect the system fan cable from the connector on the system board.
3. Remove the four (M2x5) screws that secure the system fan to the system board.
4. Lift the system fan off the system board.
Installing the system fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the system fan and provides a visual representation of the installation procedure.
Removing and installing components
31