Service Manual

To replace the display latch, you must remove the whole bezel.
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the hard drive.
3. Remove the keyboard.
4. Openthedisplay180degrees,andremovethetworubberscrewcovers,fourrubberscrewbumpers,andthesixM2.5x4-mm screws that secure the
bezel.



5. Use your fingers to carefully pry around the perimeter of the bezel until the bezel separates from the display assembly.
6. Remove the two display latch screws, and remove the display latch.




Back to Contents Page

1
rubber screw bumpers
6U549
2
bezel

3
rubber screw covers
2U940
4
M2.5 x 4-mm screws
7116P
1
M2 x 1.8-mm screws (2)
5H953
2
display latch

NOTICE: When you replace the bezel, ensure that the display cable is routed correctly.