Service Manual

1. Remove the new drive from its packaging.

Save the original packaging for storing or shipping the hard drive.
2. Slide the hard drive into the bay until it is fully seated.
3. Replace and tighten the two M3 x 3-mm screws.
4. Use the Operating System CD to install the operating system for your computer.
5. Use the Drivers and Utilities CD to install the drivers and utilities for your computer.

Removing the Interposer
1. Follow the instructions in "Preparing to Work Inside the Computer" to remove the battery and prepare the computer for work.
2. Remove the hard drive.
3. Remove the two M3 x 3-mm screws from the side of the hard drive, and remove the hard drive carrier.



4. Carefully remove the interposer by pulling it straight off the hard drive.



1
M3 x 3-mm screws (2)
2864D
2
hard drive carrier
7X499
1
interposer
8267R