User's Manual

Using Cards 69

Removing a PC Card or Blank

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the

Product Information Guide

and see "Before Working Inside Your Computer" on page 112.

NOTICE: Use the PC Card configuration utility (click the icon in the taskbar) to select a card and

stop it from functioning before you remove it from the computer. If you do not stop the card in the

configuration utility, you could lose data. Do not attempt to eject a card by pulling its cable, if one is

attached.

Press the latch and remove the card or blank. For some latches, you must press the latch twice: once

to pop the latch out, and then a second time to pop the card out.

Save a blank to use when no PC Card is installed in a slot. Blanks protect unused slots from dust

and other particles.

1 slot 2 ExpressCard