Owner's manual

Back to Contents Page
 Keyboard
Dell™Latitude™D820ServiceManual

1. Follow the procedures in Before You Begin.

2. Remove the hinge cover (see Hinge Cover).

3. Remove the three screws at the top of the keyboard.

4. Rotate the keyboard forward and lay it on the palm rest to allow access to the keyboard connector on the system board.

5. Pull up on the pull-tab to disconnect the keyboard cable connector from the keyboard connector on the system board.

6. To replace the keyboard, connect the keyboard cable connector to the keyboard connector on the system board.

7. Place the tabs along the front edge of the keyboard into the palm rest and lay the keyboard down on the palm rest.

8. Replace the three screws at the top of the keyboard.

9. Replace the hinge cover.
Back to Contents Page

CAUTION: BeforeworkinginsideyourDell™computer,followthesafetyinstructionsinyourProductInformationGuide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.
NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
1
keyboard
2
keyboard screws
3
keyboard cable connector
4
keyboard connector




NOTICE: To avoid scratching the palm rest when replacing the keyboard, hook the tabs along the front edge of the keyboard into the palm rest, and
then secure the keyboard in place.