Owner's Manual

Installing the Coin-Cell Battery

1. Place the coin-cell battery in its slot.

2. Connect the coin-cell battery cable to the system board.

3. Install:

a) base cover

b) battery

4. Follow the procedures in

After Working Inside Your Computer

Removing the Power Connector

1. Follow the procedures in

Before Working Inside Your Computer

2. Remove:

a) battery

b) base corner cap (right)

c) base cover

3. Perform the following steps as shown in the illustration:

a) Disconnect the power-connector cable.

b) Release the power-connector cable from the routing channel.

c) Remove the screw that secures the power-connector bracket to the computer.

4. Lift the power-connector bracket from the computer. Lift the power connector from the computer.