Service manual

Display Assembly and Display Latch: Dell Latitude V710/V740 Service Manual
1 screw covers (5) 6 M2 x 3-mm screws (4)
2 M2.5 x 5-mm screws
(5)
7 M2.5 x 5-mm screw (1)
3 display bezel 8 display-feed flex cable
4 display panel 9 flex-cable retention
bracket
5 M2.5 x 5-mm screws
(2)
10 top cover
Removing the Display Bezel
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and
remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching
an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing the following
procedure.
1. Remove the
keyboard.
2. Remove the
display assembly.
3. Use a plastic scribe to pry the five screw covers out of the screw holes located on the front
of the bezel.
4. Remove the five M2.5 x 5-mm screws located on the front of the bezel.
NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.
5. Starting at the bottom of the display panel (by the Dell™ logo), use your fingers to
separate the bezel from the top cover by lifting the inside of the bezel while pushing in on
the outside.
Removing the Display Panel
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and
remove any installed batteries.
file:///F|/Service%20Manuals/Dell/Latitude/v710-740/display.htm (5 of 10) [2/28/2004 8:22:14 AM]