Service manual

Microprocessor Thermal-Cooling Assembly: Dell Latitude V710/V740 Service Manual
Back to Contents Page
Microprocessor Thermal-Cooling
Assembly
Dell™ Latitude™ V710/V740 Service Manual
Removing the Microprocessor Thermal-Cooling
Assembly
NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by
touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing the
following procedure.
1. Remove the
keyboard.
2. Remove the
EMI Shield.
NOTE: You can remove the microprocessor thermal-cooling assembly with the
fan attached.
3. Disconnect the fan power cable from the system board.
4. Loosen in consecutive order the four captive screws, labeled 1 through 4, that
secure the microprocessor thermal-cooling assembly to the system board.
file:///F|/Service%20Manuals/Dell/Latitude/v710-740/thermal.htm (1 of 3) [2/28/2004 8:22:16 AM]