Service manual

System Board: Dell Latitude V710/V740 Service Manual
1 video-connector hex
nuts
2 parallel-connector hex
nuts
3 headphone/microphone
flex-panel
19. Remove the two hex nuts that secure the video connector to the bottom case.
20. Remove the two hex nuts that secure the parallel connector to the bottom case.
21. Pull the headphone/microphone flex-panel away from the system board as you
simultaneously lift the front of the system board out and away from the bottom case.
Replacing the System Board
NOTICE: For V740 only, prior to replacing the system board, ensure that a thermal pad
is present on the Memory Controller Hub (MCH) heat-sink, located on the base plastics. If
a thermal pad is already present, you do not need to replace it.
1. Install the replacement system board:
a. Insert the video connector through the back of the bottom case.
b. Pull the headphone and microphone flex-panel away from the system board as you
simultaneously lower the front of the system board into the bottom case.
file:///F|/Service%20Manuals/Dell/Latitude/v710-740/sysboard.htm (5 of 8) [2/28/2004 8:22:19 AM]