Owners Manual

Troubleshooting Your Wide LCD Monitor 83
Poor picture quality when using a device
connected to the ANT/Cable (coaxial)
connector
1 Ensure wide LCD monitor is selected as the input
source in the
Input Select menu. See "Input Select
Menu" on page 74 for more information.
2 Press Menu on the remote control, select Setup , and
then select
Channel Setup . This resets the channels.
3 Check the aspect ratio settings in the OSD. Press the
Menu button on the remote control and select Size . For
more information on using the OSD, see "Using the On-
Screen Display" on page 73.
4 Reset the original factory defaults. Press Menu on the
remote control, select
Setup , and then select Factory
Reset
.
5 Adjust the color temperature. Press Menu on the remote
control, select
Picture , and then select Color
Tem pe ra tu re
.
6 The problem may be with your device, contact your
service provider.
Nothing appears on my wide LCD m onitor 1 Ensure the wide LCD monitor is turned on.
2 Verify that all the cables are properly connected to the
wide LCD monitor , including the power cable.
3 Check to see if there is a blue or amber light on the
lower, right-hand corner of the wide LCD monitor . A
blue light indicates the wide LCD monitor is on. An
amber light, means the wide LCD monitor is in power
save mode.
4 Ensure the proper source is selected in the Input Select
menu. See "Input Select Menu" on page 74 for more
information.
5 Reconnect any devices that are currently connected to
the wide LCD monitor . If you are using multiple
devices, connect and test one device at a time.
6 Connect another device that you know is working
properly.
7 Reset the original factory defaults. Press Menu on the
remote control, select
Setup , and then select Factory
Reset
.
Problem Possible Solution
W2600A00.book 83 ページ ２００４年８月４日 水曜日 午後６時４８分