Web Services Interface Guide

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Linux Version: 2.1.0
159
EXAMPLE:
wsman invoke -a SetAttribute http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_NICService
?SystemCreationClassName=DCIM_ComputerSystem,CreationClassName=DCIM_NICService,SystemNam
e=DCIM:ComputerSystem,Name=DCIM:NICService
-h $IPADDRESS -V -v -c dummy.cert -P 443
-u $USERNAME -p $PASSWORD -J SetAttribute_NIC_LegacyBootProto.xml
-j utf-8 -y basic
The input file SetAttribute_NIC.xml is shown below:
<p:SetAttributes_INPUT xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_NICService">
<p:Target>NIC.Embedded.1-1</p:Target>
<p:AttributeName>LegacyBootProto</p:AttributeName>
<p:AttributeValue>PXE</p:AttributeValue>
</p:SetAttributes_INPUT>
OUTPUT:
<n1:SetAttribute_OUTPUT>
<n1:Message>The command was successful</n1:Message>
<n1:MessageID>NIC001</n1:MessageID>
<n1:RebootRequired>Yes</n1:RebootRequired >
<n1:ReturnValue>0</n1:ReturnValue>
<n1:SetResult>Set PendingValue</n1:SetResult >
</n1:SetAttribute_OUTPUT>
15.14 Setting CNA LAN Modes
The SetAttributes() method is used to set or change the values of a group of NIC attributes.
Invoke SetAttributes() with the following parameters (from Section 15.1) and syntax:
Target: FQDD attained through DCIM_NICEnumeration
AttributeName: Attained from AttributeName field
AttributeValue: A new value to assign to the specified NICAttribute. If this value is valid, it
will be applied to the PendingValue property or the Currentvalue property of the specified
NICAttribute. Possible choices are attained from PossibleValues field.
EXAMPLE:
wsman invoke -a SetAttributes http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_NIC
Service?SystemCreationClassName=DCIM_ComputerSystem,CreationClassName=DCIM_NICService,Syst
emName=D