Web Services Interface Guide

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Linux Version: 2.1.0
228
<p:AttributeName>Users.16#IpmiLanPrivilege</p:AttributeName>
<p:AttributeValue>Administrator</p:AttributeValue>
<p:AttributeName>Users.3#IpmiSerialPrivilege</p:AttributeName>
<p:AttributeValue>Administrator</p:AttributeValue>
…
<p:AttributeName>Users.16#IpmiSerialPrivilege</p:AttributeName>
<p:AttributeValue>Administrator</p:AttributeValue>
</p:ApplyAttributes_INPUT>
OUTPUT:
<n1:ApplyAttributes_OUTPUT>
<n1:Job>
<wsa:Address>http://schemas.xmlsoap.org/ws/2004/08/addressing/role/anonymous</wsa:Address>
<wsa:ReferenceParameters>
<wsman:ResourceURI>http://schemas.dell.com/wbem/wscim/1/cim-
schema/2/DCIM_LifecycleJob</wsman:ResourceURI>
<wsman:SelectorSet>
<wsman:Selector Name="InstanceID">JID_001300815142</wsman:Selector>
<wsman:Selector Name="__cimnamespace">root/dcim</wsman:Selector>
</wsman:SelectorSet>
</wsa:ReferenceParameters>
</n1:Job>
<n1:ReturnValue>4096</n1:ReturnValue>
</n1:ApplyAttributes_OUTPUT>
19.4.2 Polling Job Completion
Use the Get() command to check the progress of the ApplyAttributes() method. It polls for job
completion. This method takes the InstanceID from the previous section (19.3.1) as input. The
JobStatus value is either “Successful” or “Failed”. If the job failed, the Message value contains more
detailed error information on the cause of the failure.
Run the Get() command on DCIM_LifecycleJob with the following parameters and syntax:
EXAMPLE:
wsman get http://schemas.dmtf.org/wbem/wscim/1/cim-schema/2/root/dcim/DCIM_LifecycleJob
?InstanceID=$INSTANCEID -h $IPADDRESS -V -v -c dummy.cert -P 443 -u $USERNAME -p $PASSWORD -j
utf-8 –y basic
The input parameter is the InstanceID from the output of the ApplyAttributes() method. An example
InstanceID is as follows: InstanceID = JID_ 001300815142