User's Manual

52 USC and USC - LCE
• To assign a hot spare to the virtual disk, select the Assign a Hot Spare Disk
check box. A hot spare is an unused backup physical disk that can be used
to rebuild data from a redundant virtual disk.
• Select the physical disk to be used as the hot spare from the
Hot Spare
Disk
drop-down menu.
NOTE: A hot spare can be used only with a redundant RAID level. Hot spares
also have requirements for physical disk size. The hot spare cannot be smaller
than the smallest physical disk included in the virtual disk. If the RAID level
and physical disk availability do not meet these requirements, the Assign a
Hot Spare Disk check box is disabled.
Click Next after making your selection.
Advanced Wizard Only - Review Summary
The Summary screen displays the virtual disk attributes based on your selections.
CAUTION: Clicking the Finish button deletes all existing virtual disks except for
any foreign configurations that you specified should be kept. All data residing on
the deleted virtual disks will be lost.
Click Finish to create a virtual disk with the displayed attributes.
OR
To return to a previous screen to review or change selections, click Back. To
exit the Wizard without making changes, click Cancel.
Advanced Configuration
Use Advanced Configuration to modify advanced settings.
1
Select Hardware Configuration from the left menu
2 Click Advanced Configuration in the right panel.
3 Select the device you want to configure.
NOTE: Depending on the configuration setting changes, the following message
may be displayed: One or more of the settings requires a reboot to be saved and
activated. Do you want to reboot now?. You can select No and continue making
additional configuration changes or perform other tasks such as operating system
deployment. All changes will be applied during the next system boot.
LC1_2.book Page 52 Wednesday, November 18, 2009 9:42 AM