User's Manual

Troubleshooting and Frequently Asked Questions 77
An error occurred. One
or more settings may
not be saved.
An error occurred when changing Hardware Advanced
Configuration settings. To resolve this issue:
1 Reboot the system.
2 Re-enter USC - LCE by pressing the <F10> key.
3 Change the settings again.
An error occurred. One
or more settings may
not be restored.
An error occurred when restoring Hardware Advanced
Configuration settings. To resolve this issue:
1 Reboot the system.
2 Re-enter USC - LCE by pressing the <F10> key.
3 Re-open the Advanced Configuration screen.
This feature is not
supported in this
configuration
Your modular system does not support the
feature you selected.
Table A-4. Lifecycle Controller Error Messages and Resolutions
Error Message Resolution
General failure An error has occurred. No other details are available
at this time.
1 Run the command again.
2 Reset iDRAC and run the command.
Lifecycle Controller is
being used by another
process
Lifecycle Controller is currently locked by another process.
Ensure that the process is completed before attempting to
run another command.
1 Run the command again after sometime.
2 Ensure that USC or DUP is not running.
3 Reset iDRAC and run the command
Table A-3. USC - LCE Error Messages and Resolutions (continued)
Error Message Resolution
LC1_2.book Page 77 Wednesday, November 18, 2009 9:42 AM