User's Manual

40 USC and USC - LCE
To return to the Configuration Wizards screen, click Back. To exit the
wizard, click Cancel.
iDRAC Configuration
Use the iDRAC Configuration Wizard to configure and manage
iDRAC parameters.
This wizard is similar to the iDRAC Configuration Utility in the legacy
BIOS operation. You can use the wizard to configure iDRAC parameters
applicable to the system, such as LAN, common IP settings, IPv4, IPv6,
virtual media, and LAN user configuration.
To launch the iDRAC Configuration Wizard:
1
Click Hardware Configuration in the left pane.
2 Click Configuration Wizards in the right pane.
3 Click iDRAC Configuration to launch the wizard.
The following steps will walk you through the iDRAC Configuration Wizard:
a "LAN Configuration"
b "Advanced LAN Configuration"
c "Common IP Configuration"
d "IPv4 Configuration"
e "IPv6 Configuration"
f "Virtual Media Configuration"
g "LAN User Configuration"
h "Confirmation"
LAN Configuration
View or configure iDRAC LAN, IPMI over LAN, MAC address,
and NIC selection.
• iDRAC LAN — Enables or disables the iDRAC NIC. Disabling
iDRAC LAN deactivates the remaining controls.
•
IPMI Over LAN — Enables or disables Intelligent Platform
Management Interface (IPMI) commands on the iDRAC
Local Area Network (LAN) channel.
LC1_3.book Page 40 Monday, December 7, 2009 3:14 PM