Users Guide

20 Getting Started With USC or USC-LCE
1 Launch USC Settings Wizard:
a Boot your system and press the <F10> key within 10 seconds of the
Dell logo being displayed.
b Wait until USC Home screen is displayed, then click USC Settings in
the left pane.
2 Click Language and Keyboard in the right pane. Use the up-arrow and
down-arrow keys to access all options on the
Language and Keyboard Type
drop-down menus.
a Select the language from the Language drop-down menu.
b Select the type of keyboard you are using from the Keyboard Type
drop-down menu.
c Click Finish .
3 Click Network Settings in the right pane.
a Use the NIC Card drop-down menu to select the NIC card you want
to configure on your system.
b Use the IP Address Source drop-down menu to select either No
Configuration
, DHCP , or Static IP . The IP Address Source function
only supports IPv4.
• No Configuration — Select if you do not want to configure your
NIC.
• DHCP — Select to obtain an IP address from a DHCP server.
• Static IP — Select to use a static IP address. Specify the following
IP
address properties. If you do not have this information, see
your network administrator.
–IP Address
–Subnet Mask
–Default Gateway
– DNS Address
c Click Finish .
If USC settings are not configured correctly, an error message is displayed.
LC1_4.book Page 20 Friday, October 22, 2010 2:45 AM