Users Guide

USC and USC - LCE 55
d "Select the Express or Advanced Wizard" on page 56
e "Select Basic Settings" on page 57
f "Express Wizard Only - Assign a Hot Spare" on page 58
g "Express Wizard Only - Review Summary" on page 58
h "Advanced Wizard Only - Select Physical Disks" on page 59
i "Advanced Wizard Only - Additional Settings" on page 60
j "Advanced Wizard Only - Review Summary" on page 61
View Current Configuration
The View Current Configuration screen displays the attributes of
any virtual disks already configured on the supported RAID controllers
attached to the system. You have two options:
• Accept the existing virtual disks without making changes. To select this
option, click
Back . If you intend to install the operating system on an
existing virtual disk, ensure that the virtual disk size and RAID level are
appropriate.
• Delete all existing virtual disks and use the RAID configuration wizard
to
create a single, new virtual disk to be used as the new boot device.
To
select this option, click Next .
NOTE: RAID 0 does not provide data redundancy. Other RAID levels provide
data redundancy and may enable you to reconstruct data in the event of a
disk failure.
Select RAID Controller
The Select RAID Controller screen displays all supported RAID controllers
attached to the system. Select the RAID controller on which you want to
create the virtual disk, and then click Next.
Foreign Configuration Found
The Foreign Configuration Found screen displays only if a foreign
configuration resides on the selected RAID controller.
LC1_4.book Page 55 Friday, October 22, 2010 2:45 AM