User Manual

Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx #5 (T5) screwdriver
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
Base cover T5, M2x3 8
M.2 2230 solid state drive
NOTE: For computers
shipped with M.2 2230 solid
state drive.
M2x2 2
M.2 2280 solid state drive
NOTE: For computers
shipped with M.2 2280 solid
state drive.
M2x2 1
Battery M2x4 5
Left fan M2x4 2
Right fan M2x4 2
2
10 Removing and installing components