User Manual

2. Use a scribe to pry from the gap at the bottom-left corner of the base cover. Then slide the scribe towards the middle of
bottom side, and then the left side of the system to disengage the clips. Repeat the same process for the other side of the
system.
NOTE: Do NOT pry up from the top side (near the vents) of the base cover as it can damage the rear side of the cover.
CAUTION: Only use the plastic scribe to disengage and release the clips with the prying motion along the
edges of the base cover. Do NOT use your fingers.
3. Lift the base cover starting from the bottom edge and push it towards the rear to remove it from the computer.
4. Disconnect the battery cable from the connector on the system board.
NOTE: Pull the pull tab vertically to disconnect the battery cable.
Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the base cover and provides a visual representation of the installation procedure.
Removing and installing components
15