User Manual
Table Of Contents
- Precision 5470 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Remove the (M2x2) screw that secures the SSD thermal plate to the M.2 2280 solid state drive.
2. Lift to remove the SSD thermal plate.
3. Lift the M.2 2280 solid state drive at an angle and slide to remove from its slot on the system board.
Installing the M.2 2280 solid state drive
Prerequisites
NOTE: For computers shipped with M.2 2280 solid state drive.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the M.2 2280 solid state drive and provides a visual representation of the installation
procedure.
20
Removing and installing components