User Manual

Steps
1. Align the screw holes on right fan with the screw holes on the palm-rest and keyboard assembly.
2. Connect the right fan cable to the system board.
3. Replace the two (M2x4) screws that secure the right fan to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Heat sink
Removing the heat-sink for Integrated graphics
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The figure indicates the location of the heat-sink and provides a visual representation of the removal procedure.
Steps
1. Loosen the four captive screws that secure the heat-sink to the system board.
NOTE:
Loosen the captive screws in the order that is marked on the heat-sink assembly next to the screws [4 > 3 > 2 >
1].
2. Carefully lift the heat-sink to remove it from the system board.
30
Removing and installing components