User Manual
Table Of Contents
- Precision 5470 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
8. Remove the system board.
NOTE: The system board can be removed or installed together with the heat-sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat-sink.
About this task
The figure indicates the location of the USH board and provides a visual representation of the removal procedure.
Steps
1. Remove the two (M1.4x1.2) screws that secure the USH board flat printed cable on the system board.
2. Remove the USH board flat printed cable from the system board.
Installing the USH board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the USH board and provides a visual representation of the installation procedure.
Removing and installing components
59