User Manual

Installing 3-cell battery

1 Insert the battery into the slot on the computer.

2 Route the battery cable through the routing clip and connect the battery cable to the connector on the system board.

NOTE

: Route the battery cable, if the cable at the base of the battery is un-routed.

3 Replace the M2.0 x 5.0 screw to secure the battery to the computer.

4 Install the base cover

5 Follow the procedure in After working inside your computer.

Removing 4-cell battery

1 Follow the procedure in Before working inside your computer.

2 Remove the base cover.

3 To remove the battery:

a Disconnect the battery cable from the connector on the system board [1].

b Remove the two M2.0 x 5.0 screw that secure the battery to the computer[2].

c Lift the battery from the computer [3].

Removing and installing components