Owner's Manual

Fabric OS v6.3.1_dcb5 for DELL M8428-k Release Notes 1.0 Draft Page 13 of 23
On Table 91 – Supported Distances
Add the Brocade 8428-k model with the following table information
Switch/blade
model
2 Gbps
4 Gbps
8 Gbps
M8428-k 582 291 145
Brocade Access Gateway Administrator’s Guide (Publication Number 53-
1001345-01)
On Table 5 – Access Gateway default F-port to N-port mapping (page 53)
Brocade Model
Total Ports
GE-ports
N-ports
Default GE_ to N_Port Mapping
M8428-k
28
1-24
0,25,26,27
1, 2, 3, 4, 17, 18 mapped to 25
5, 6, 7, 8, 19, 20 mapped to 26
9, 10, 11, 12, 21, 22 mapped to 27
13, 14, 15, 16, 23, 24 mapped to 0
The Failover and Failback are enabled by default on all N_ports. The PG policy is enabled by default. The APC
and ADS policies are disabled by default.
Defects
Defects Closed with Code Change in Fabric OS v6.3.1_dcb5
This section lists defects with Critical, High and Medium Technical Severity closed in Fabric OS
v6.3.1_dcb5.
Note that when a workaround to an issue is available, it is provided; otherwise, no recommended
workaround is available at this time.
Defect ID:
DEFECT000282759
Technical Severity:
Medium
Summary:
Switches in Access Gateway (AG) mode are not handling multi-sequence frames properly. This
causes memory corruption and switch panic.
Symptom:
One or more switches in AG mode in the same fabric have an agdd panic occur. RASLOG error
messages such as "[KSWD-1002], 1285, FFDC | CHASSIS, WARNING, Brocade300, Detected
termination of process agd0:1793" are seen and then debug information is dumped.
Probability:
Low
Feature:
FOS Software
Function:
Access Gateway
Reported In Release:
FOS6.3.0
Service Request ID:
419851