Release Notes

11 | P a g e
Issue 20: Saving the alarm settings during a Restore Default Alarms causes UI to hang.
Description: It is possible to save the Events and Alarms settings while the
Restore Default Alarms method is still running. Clicking Restore Default
Alarms calls the method immediately, but does not block the UI - it just disables
the Restore Default Alarms button. Saving while the call is still in progress
may result in an error where the Save spinner does not close, locking the user
out of the UI.
Resolution: To avoid this error completely, when clicking Restore Default
Alarms, wait to do any other actions until the Restore Default Alarms button
is re-enabled. This button is disabled while the call is in progress. Once the
button is enabled again, you can safely save the page. If the spinner is not going
away, exit vSphere and reload the Dell Management Plug-in. This applies to both
the Settings page and Config Wizard page.
Version Affected: 1.0, 1.0.1, 1.0.1 Update 1
Issue 21: Single DUP update continues without using the Apply Update selection method.
Description: When you don’t select an option on the last page of the firmware
update using the Single Firmware Update method, the default behavior is
applied the update on next reboot.
Resolution: If this situation happens, manage the reboot of the host to get the
selected update to reply. To avoid this situation, always make the selection on
the reboot page prior to proceeding with the firmware update.
Version Affected: 1.0, 1.0.1, 1.0.1 Update 1
Issue 22: Proxy Test failure
Description: If proxy test failed, try to ping the website that you used to test proxy to
make sure the website is not down.
Resolution: If you can ping the website, then try the test proxy again and it should
work.
Version Affected: 1.0, 1.0.1, 1.0.1 Update 1