Release Notes

14 | P a g e
Bug#: DF489662
Fixed Issue3: Re-running compliancy check on Lifecycle Controller 1.3 based servers
deletes the service tag.
Bug#: DF485000
Fixed Issue 4: An Unknown Exception occurred while accessing Firmware information
on the Dell Tab. This happens due to the warranty service proxy issue. Inventory
service did not get the iDRAC IP, which causes the firmware service to throw an
unknown exception.
Bug#: DF484068
Fixed Issue 5: The deployment failed due to exception of parallel processing conflicts
while updating.
Bug#: DF484713
Fixed Issue 6: The Dell Management Plug-in fails to forward events to vCenter. If you
have not made any changes to the default alert settings and if you do not follow every
step of the upgrade instructions to 1.0.1 then the new appliance won’t send alerts to
any vCenter that registered with the upgraded appliance.
Bug#: DF484717
Fixed Issue 7: The ESXi deploy fails to configure the correct LOM interface. If you
have multiple MAC addresses that are not in teaming mode, and take the MAC address
that is not wired for use by the Dell Management Plug‐in, then DHCP fails.
Bug#: DF481089
Fixed Issue 8: iDRAC attribute value set failure messaging. For servers using LC 1.5,
the iDRAC configuration only supports a subset of iDRAC attributes. If you modify the
HWP to change unsupported LC 1.5 iDRAC settings, the Dell Management Plugin gives
an error message but continues with the deployment job. LC 2.0 supports the
complete set of iDRAC attributes.
Bug#: DF484450
Fixed Issue 9: Dell Management Plug-in lets you send more than one NIC update. Only
one is successful.
Bug#: DF487949
Fixed Issue 10: Successful Deployment applied incorrect Boot Order on Target Host.
Bug#: DF488342
Fixed Issue 11: iDRAC user not added to target system after successful deployment.
iDRAC user changes done on custom Hardware configuration were not applied when
no hypervisor profile was selected in deployment template.
Bug#: DF488692
Fixed Issue 12: Changes to BIOS settings sometimes revert to original state. Changes
done to customize hardware configuration on Hardware profile were not saved.