CLI Guide

article. The new SPC version is applied to all the initiators
in the storage-view. Continue? (Yes/No) Yes
VPlexcli:/clusters/cluster-1/exports/storage-views/test_view_1> ll
Name Value
------------------------
-----------------------------------------------------------------------------------------
---------------
caw-enabled true
controller-tag -
initiators [test_port]
operational-status ok
port-name-enabled-status [P0000000043E00BDD-A0-FC00,true,ok, P0000000043E00BDD-A0-
FC01,true,ok,
P0000000043F00BDD-B0-FC00,true,ok, P0000000043F00BDD-B0-
FC01,true,ok]
ports [P0000000043E00BDD-A0-FC00, P0000000043E00BDD-A0-FC01,
P0000000043F00BDD-B0-FC00,
P0000000043F00BDD-B0-FC01]
scsi-spc-version 3
virtual-volumes [(0,device_C1-
RHEL_XtremIO0547_LUN_00001_1_vol,VPD83T3:6000144000000010f00bddd268733d19,200G)]
write-same-16-enabled true
xcopy-enabled true
See also
● storage-volume claim
● storage-volume unclaim
set topology
Changes the topology attribute for a Fibre Channel port.
Contexts
/clusters/cluster/directors/director/hardware/ports/port
Syntax
set topology
[p2p|loop]
Arguments
Required
arguments
p2p Sets the port’s topology as point-to-point. The port comes up as an F-port.
Use the p2p topology to connect the Fibre Channel fabric to a node.
loop Sets the port’s topology as loop. The port comes up as an FL-Port.
Use the loop topology to connect a Fibre Channel Arbitrated Loop (ring-style network topology) to a fabric.
Commands 279