CLI Guide

Newer protocol-compliant SCSI devices return a notification code when the exported set changes, and may not require
manual synchronization. Older devices that do not return a notification, must be manually synchronized.
● When the array is not experiencing I/O (the transport interface is idle), there is no mechanism by which to collect the
notification code. In this scenario, do one of the following:
○ Wait until I/O is attempted on any of the LUNs,
○ Disruptively disconnect and reconnect the array, or
○ Use the array rediscover command.
CAUTION: This command cannot detect LUN-swapping conditions on the arrays being re-discovered. On
older configurations, this might disrupt I/O on more than the given array.
Use the ll /clusters/*/storage-elements/storage-arrays/ command to display the names of storage arrays.
Examples
In the following example:
● The ll /clusters/*/storage-elements/storage-arrays/ command displays the names of storage arrays.
● The array re-discover command re-discovers a specified array:
34 Commands