Reference Guide
Table Of Contents
- Dell EMC Storage Systems Events and Alerts Guide for the metro node appliance
- Contents
- Events and Alerts
- UI overview
- Platform alerts
- Hardware alerts
- Alert states
- Scope of the events
- Sorting and filtering alerts
- Download .csv
- Default and hidden columns
- Live alerts
- Alerts roll-up
- Historical alerts
- Alerts on remote director
- Configure alerts
- Service Monitoring Alert
- Test alerts for platform, monitor, and SMS
- Heartbeat alerts
- Mail notification
- Configure emailing notification
- Test email alert
- Supported events
Figure 1. Disabling particular component of platform alerts
If user enables it again, then it starts showing up future alerts that are associated with the component level in the UI.
Disable or enable hardware alerts
In hardware alerts, user can disable the entire iDRAC alerts or Monitor alerts or both.
Steps:
1. In the UI, go to the Settings.
2. Select Notifications from drop-down. The Configure Alerts page is displayed.
3. Click the CONFIGURE NOTIFICATIONS button. A Configure Notification window is displayed.
4. In the Hardware Alerts section, to disable the particular component, switch the button, and then click CLOSE to close the
window.
Figure 2. Disabling particular component of hardware alerts
If user enables it again, then it starts showing up future alerts that are associated with the hardware alerts in the UI.
Disable or enable alerts based on the component group
The alerts can be disabled at the component group level which means that the alerts associated with all components of that
component group are not displayed in the UI.
There are two component groups: Platform alerts and Hardware alerts. The user can disable either of them or both as well.
12
Events and Alerts