Installation Instructions and Important Information

28 Installation Instructions and Important Information
See Microsoft Knowledge Base articles KB246184 and KB254078
located on the Microsoft Support website at
www.microsoft.com for
information on adding third-party original equipment manufacturer
(OEM) drivers to a RIS image.
NOTE: To install the operating system remotely using RIS, the target
systems must support remote booting.
Tape Drives
The following issues pertain to the Removable Storage console—a storage
management console in the Computer Management console tree that
allows you to track your removable storage media and manage the tape
autoloaders that are connected to your system.
NOTE: The Removable Storage console is also known as the Removable
Storage Management (RSM) Console.
• The Dell PowerVault™ 120T DLT1 autoloader does not respond
to Eject or Inject commands.
When an Eject or Inject command is issued from the Removable
Storage
console to any tape media in a PowerVault 120T digital linear
tape 1 (DLT1) autoloader, the following message appears:
The resource required for this operation does
not exist.
The PowerVault 120T DLT1 autoloader is not equipped to respond to
Eject or Inject commands from the Removable Storage console.
To avoid this issue, manually add or remove the DLT cartridge(s) from
the autoloader without using the commands from the
Removable
Storage
console.
• The PowerVault 122T LTO autoloader Cleaner Management
operation fails after you install Service Pack 4.
When you insert a cleaning tape into the PowerVault 122T LTO
autoloader using the Cleaner Management wizard in Windows 2000
with Service Pack 4, the Reserve Cleaner operation fails, and the system
is unable to identify the tape media. If the Reserve Cleaner operation
completes successfully, then the next Clean Drive operation fails. In
both cases, the cleaning tape cannot be used to clean the drive from
the
Removable Storage console.