Deployment Guide

19
be set from the value in a priority VLAN tag rather than default to zero in the case of a packet without a VLAN
tag.
Note: A VLAN Flow Table rule cannot specify an IN_PORT and VLAN_VID combination that is used in a VXLAN
Access Logical Port configuration. Conversely, it must include a rule to permit an IN_PORT and VLAN_VID
combination used in a VXLAN Tunnel Next H
Table 8. VLAN Flow Table Instructions
Name
Argument
Description
Apply-Actions
Action List
The VLAN Flow Table supports the actions specified in Table 13.
Goto-Table
Table
For VLAN filtering or Port VLAN assignment the next table should
be the Termination MAC Flow Table.
The VLAN table uses Apply Actions for port VLAN tagging and assignment. The action list can have at most
one of each action type.
Table 9: VLAN Flow Table Action List
Name
Argument
Description
Set
Field
VLAN_VID, must be
between 1 and 4094.
Sets the VLAN id on the outermost tag. If the packet is untagged
then one is pushed with the specified VLAN id and priority zero.
Set
Field
VRF
Optionally sets the VRF pipeline field. VRF must be the same in all
rules for the same VLAN.
Push
VLAN
TPID
Used in translating single to double tag. TPID must be 0x8100
(inner VLAN tag) or 0x88a8 (outer VLAN tag).
Note: The untagged packet action is the same as in OpenFlow 1.0. The implicit addition of a tag to an
untagged packet is tolerated but not condoned in OpenFlow 1.3.4.
Only hard interval time-out ageing per entry is supported, as indicated in Table 9.