Deployment Guide

75
show interfaces configuration command
Shows the interfaces configuration information.
Examples
FJ6K0Z1_console> show interfaces
show interfaces <subcommand>
possible subcommands:
configuration show interfaces configuration information
status show interfaces status information
switchport show operational status of an interface
FJ6K0Z1_console> show interfaces configuration ?
show interfaces configuration
Show configuration information for all available interfaces.
FJ6K0Z1_console> show interfaces configuration
Port Duplex Speed Neg MTU Admin State
---- ------ ----- ------ ----- -----------
1 half 0 auto 16356 enabled
2 half 0 auto 16356 enabled
3 half 0 auto 16356 enabled
4 half 0 auto 16356 enabled
5 half 0 auto 16356 enabled
6 half 0 auto 16356 enabled
7 half 0 auto 16356 enabled
8 half 0 auto 16356 enabled
9 half 0 auto 16356 enabled
10 half 0 auto 16356 enabled
11 half 0 auto 16356 enabled
12 half 0 auto 16356 enabled
13 half 0 auto 16356 enabled
14 half 0 auto 16356 enabled
15 half 0 auto 16356 enabled
16 half 0 auto 16356 enabled
17 half 0 auto 16356 enabled
18 half 0 auto 16356 enabled
19 half 0 auto 16356 enabled
20 half 0 auto 16356 enabled
21 half 0 auto 16356 enabled
22 half 0 auto 16356 enabled
23 full 1000 auto 16356 enabled
24 full 1000 auto 16356 enabled
50 full 10000 noauto 16356 enabled
51 full 10000 noauto 16356 enabled
NOTE: the port numbering shown with a gap in port numbers is consistent with the way this is done in
traditional PowerConnect images, however this diverges from the way ports are handled in both
OpenFlow and in many other switch vendors. The port naming reflected back in the GetFeatures
OpenFlow response has the ports named as seen in traditional PowerConnect (i.e. Te 2/0/1, Ge 1/0/1,
etc.)