Administrator Guide
Rapid Spanning Tree Protocol (RSTP)
Protocol Overview
RSTP is a Layer 2 protocol — specified by IEEE 802.1w — that is essentially the same as spanning-tree protocol (STP) but provides
faster convergence and interoperability with switches configured with STP and multiple spanning tree protocol (MSTP).
The Dell EMC Networking OS supports three other variations of spanning tree, as shown in the following table.
Table 68. Spanning Tree Variations Dell EMC Networking OS Supports
Dell EMC Networking Term IEEE Specification
Spanning Tree Protocol (STP) 802.1d
Rapid Spanning Tree Protocol (RSTP) 802.1w
Multiple Spanning Tree Protocol (MSTP) 802.1s
Per-VLAN Spanning Tree Plus (PVST+) Third Party
Configuring Rapid Spanning Tree
Configuring RSTP is a two-step process.
1. Configure interfaces for Layer 2.
2. Enable the rapid spanning tree protocol.
Related Configuration Tasks
• Adding and Removing Interfaces
• Modifying Global Parameters
• Modifying Interface Parameters
• Configuring an EdgePort
• Prevent Network Disruptions with BPDU Guard
• Influencing RSTP Root Selection
• Configuring Spanning Trees as Hitless
• Enabling SNMP Traps for Root Elections and Topology Changes
• Configuring Fast Hellos for Link State Detection
• Flush MAC Addresses after a Topology Change
Important Points to Remember
• RSTP is disabled by default.
• Dell EMC Networking OS supports only one Rapid Spanning Tree (RST) instance.
• All interfaces in virtual local area networks (VLANs) and all enabled interfaces in Layer 2 mode are automatically added to the RST
topology.
• Adding a group of ports to a range of VLANs sends multiple messages to the rapid spanning tree protocol (RSTP) task, avoid using the
range command. When using the range command, Dell EMC Networking recommends limiting the range to five ports and 40
VLANs.
46
664 Rapid Spanning Tree Protocol (RSTP)