Administrator Guide

router ospf process-id vrf vrf name
The process-id range is from 0-65535.
Configuring VRRP on a VRF Instance
You can configure the VRRP feature on interfaces that belong to a VRF instance.
In a virtualized network that consists of multiple VRFs, various overlay networks can exist on a shared physical infrastructure. Nodes
(hosts and servers) that are part of the VRFs can be configured with IP static routes for reaching specific destinations through a given
gateway in a VRF. VRRP provides high availability and protection for next-hop static routes by eliminating a single point of failure in the
default static routed network. .
Table 122. Configuring VRRP on a VRF
Task Command Syntax Command Mode
Create VRF
ip vrf vrf1
CONFIGURATION
Assign the VRF to an interface
ip vrf forwarding vrf1
INTERFACE–CONFIG
Assign an IP address to the
interface
ip address 10.1.1.1 /24
no shutdown
Configure the VRRP group and
virtual IP address
vrrp-group 10
virtual-address 10.1.1.100
show config
-----------------------------
!
interface GigabitEthernet 1/13
ip vrf forwarding vrf1
ip address 10.1.1.1/24
!
vrrp-group 10
virtual-address 10.1.1.100
no shutdown
View VRRP command output
for the VRF vrf1
show vrrp vrf vrf1
------------------
GigabitEthernet 1/13, IPv4 VRID: 10,
Version: 2, Net: 10.1.1.1
VRF: 1 vrf1
State: Master, Priority: 100, Master:
10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE,
AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv
sent: 43, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
10.1.1.100
Authentication: (none)
Configuring Management VRF
You can assign a management interface to a management VRF.
NOTE:
The loopback interface cannot be added into the management VRF.
1. Create a management VRF.
CONFIGURATION
ip vrf management
2. Assign a management port to a management VRF.
VRF MODE
Virtual Routing and Forwarding (VRF)
941