Concept Guide
Display a specic DSCP color map.
DellEMC# show qos dscp-color-map mapTWO
Dscp-color-map mapTWO
yellow 16,55
Displaying a DSCP Color Policy Conguration
To display the DSCP color policy conguration for one or all interfaces, use the show qos dscp-color-policy {summary
[interface] | detail {interface}} command in EXEC mode.
summary: Displays summary information about a color policy on one or more interfaces.
detail: Displays detailed color policy information on an interface
interface
: Enter the name of the interface that has the color policy congured.
Examples for Displaying a DSCP Color Policy
Display summary information about a color policy for one or more interfaces.
DellEMC# show qos dscp-color-policy summary
Interface dscp-color-map
GI 1/10 mapONE
GI 1/11 mapTWO
Display summary information about a color policy for a specic interface.
DellEMC# show qos dscp-color-policy summary gigabitethernet 1/10
Interface dscp-color-map
GI 1/10 mapONE
Display detailed information about a color policy for a specic interface
DellEMC# show qos dscp-color-policy detail gigabitethernet 1/10
Interface GigabitEthernet 1/10
Dscp-color-map mapONE
yellow 4,7
red 20,30
Enabling QoS Rate Adjustment
By default while rate limiting, policing, and shaping, Dell EMC Networking OS does not include the Preamble, SFD, or the IFG elds. These
elds are overhead; only the elds from MAC destination address to the CRC are used for forwarding and are included in these rate
metering calculations.
The Ethernet packet format consists of:
• Preamble: 7 bytes Preamble
• Start frame delimiter (SFD): 1 byte
• Destination MAC address: 6 bytes
• Source MAC address: 6 bytes
• Ethernet Type/Length: 2 bytes
• Payload: (variable)
• Cyclic redundancy check (CRC): 4 bytes
• Inter-frame gap (IFG): (variable)
You can optionally include overhead elds in rate metering calculations by enabling QoS rate adjustment.
QoS rate adjustment is disabled by default.
726
Quality of Service (QoS)