Setup Guide
neighbor {ip-address | ipv6-address | peer-group-name} next-hop-self [all]
If you do not use the all keyword, the next hop of only eBGP-learned routes is updated by the route reector. If you use the all
keyword, the next hop of both eBGP- and iBGP-learned routes are updated by the route reector.
• Sets the next hop address.
CONFIG-ROUTE-MAP mode
set next-hop ip-address
If the set next-hop command is applied on the out-bound interface using a route map, it takes precedence over the neighbor
next-hop-self command.
Changing the WEIGHT Attribute
To change how the WEIGHT attribute is used, enter the rst command. You can also use route maps to change this and other BGP
attributes. For example, you can include the second command in a route map to specify the next hop address.
• Assign a weight to the neighbor connection.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | ipv6-address | peer-group-name} weight weight
weight: the range is from 0 to 65535. The default is 0.
• Sets weight for the route.
CONFIG-ROUTE-MAP mode
set weight weight
weight: the range is from 0 to 65535.
NOTE
: The weight assigned using the set weight command under route map conguration override the weight
assigned using the neighbor weight command.
Example conguration for changing the WEIGHT attribute
DellEMC# configure terminal
DellEMC(conf)# router bgp 400
DellEMC(conf-router_bgp)# neighbor 10.10.10.1 remote-as 500
DellEMC(conf-router_bgp)# neighbor 10.10.10.1 weight 150
DellEMC(conf-router_bgp)# exit
In the above conguration example, the weight attribute for routes received from the neighbor 10.10.10.1 is set to 150.
To view BGP conguration, use the show config command in CONFIGURATION ROUTER BGP mode or the show running-
config bgp
command in EXEC Privilege mode.
Enabling Multipath
By default, the software allows one path to a destination. You can enable multipath to allow up to 64 parallel paths to a destination.
You can congure the maximum number of parallel routes (multipath support) to a destination in BGP.
NOTE
: Dell EMC Networking recommends
not
using multipath and add path simultaneously in a route reector.
To allow more than one path, use the following command.
• Enable multiple parallel paths.
CONFIG-ROUTER-BGP mode
Border Gateway Protocol (BGP)
231