Users Guide
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
VmanDualQos : 0
EcfmAcl : 0
FcoeAcl : 0
iscsiOptAcl : 0
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
Dell#
View CAM Usage
View the amount of CAM space available, used, and remaining in each partition (including IPv4Flow and Layer 2 ACL sub- partitions) using
the
show cam-usage command in EXEC Privilege mode
The following output shows CAM blocks usage for Layer 2 and Layer 3 ACLs and other processes that use CAM space:
Example of the show cam-usage Command
Dell#show cam-usage
Stackunit|Portpipe| CAM Partition | Total CAM | Used CAM |Available CAM
========|========|=================|=============|=============|==============
0 0 | IN-L3 ACL | 512 | 1 | 511
| | IN-V6 ACL | 0 | 0 | 0
| | IN-L2 ACL | 768 | 0 | 768
| | OUT-L3 ACL | 158 | 5 | 153
| | IN-L3 ECMP GRP| 1024 | 0 | 1024
| | OUT-V6 ACL | 158 | 0 | 158
| | OUT-L2 ACL | 206 | 7 | 199
7 | 0 | IN-L3 ACL | 512 | 1 | 511
| | IN-V6 ACL | 0 | 0 | 0
| | IN-L2 ACL | 768 | 0 | 768
| | OUT-L3 ACL | 158 | 5 | 153
| | OUT-V6 ACL | 158 | 0 | 158
| | OUT-L2 ACL | 206 | 7 | 199
Codes: * - cam usage is above 90%.
Dell#
CAM Optimization
When you enable the CAM optimization, if a Policy Map containing classication rules (ACL and/or DSCP/ ip-precedence rules) is applied
to more than one physical interface on the same port-pipe, only a single copy of the policy is written (only one FP entry is used). When you
disable this command, the system behaves as described in this chapter.
Troubleshoot CAM Proling
The following section describes CAM proling troubleshooting.
CAM Prole Mismatches
The CAM prole on all cards must match the system prole. In most cases, the system corrects mismatches by copying the correct prole
to the card, and rebooting the card. If three resets do not bring up the card, or if the system is running an Dell Networking OS version prior
to version 6.3.1.1, the system displays an error message. In this case, manually adjust the CAM conguration on the card to match the
system conguration.
To prevent mismatches, Dell Networking recommends the following:
Content Addressable Memory (CAM)
225