Users Guide
Conguration Tasks for IPv6
The following are conguration tasks for the IPv6 protocol.
• Adjusting Your CAM-Prole
• Assigning an IPv6 Address to an Interface
• Assigning a Static IPv6 Route
• Conguring Telnet with IPv6
• SNMP over IPv6
• Showing IPv6 Information
• Clearing IPv6 Routes
Adjusting Your CAM-Prole
Although adjusting your CAM-prole is not a mandatory step, if you plan to implement IPv6 ACLs, adjust your CAM settings.
The CAM space is allotted in FP blocks. The total space allocated must equal 13 FP blocks. There are 16 FP blocks, but the System Flow
requires three blocks that cannot be reallocated.
You must enter the ipv6acl allocation as a factor of 2 (2, 4, 6, 8, 10). All other prole allocations can use either even or odd-numbered
ranges.
The default option sets the CAM Prole as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
To have the changes take eect, save the new CAM settings to the startup-cong (write-mem or copy run start) then reload the
system for the new settings.
• Allocate space for IPV6 ACLs. Enter the CAM prole name then the allocated amount.
CONFIGURATION mode
cam-acl { ipv6acl }
When not selecting the default option, enter all of the proles listed and a range for each.
The total space allocated must equal 13.
The ipv6acl range must be a factor of 2.
• Show the current CAM settings.
EXEC mode or EXEC Privilege mode
show cam-acl
• Provides information on FP groups allocated for the egress acl.
CONFIGURATION mode
show cam-acl-egress
Allocate at least one group for L2ACL and IPv4 ACL.
IPv6 Routing
383