Users Guide

• To copy the running conguration, enter the keyword running-cong.

• To copy the startup conguration, enter the keyword startup-cong.

• To copy a le on the USB device, enter usbash:// followed by the lename.

In the Dell Networking OS release 9.8(0.0), HTTP services support the VRF-aware functionality. If you want the HTTP server to use a VRF

table that is attached to an interface, congure that HTTP server to use a specic routing table. You can use the ip http vrf command

to inform the HTTP server to use a specic routing table. After you congure this setting, the VRF table is used to look up the destination

address.

NOTE: To enable HTTP to be VRF-aware, as a prerequisite you must rst dene the

VRF.

You can specify either the management VRF or a nondefault VRF to congure the VRF awareness setting.

When you specify the management VRF, the copy operation that is used to transfer les to and from an HTTP server utilizes the VRF table

corresponding to the Management VRF to look up the destination. When you specify a nondefault VRF, the VRF table corresponding to

that nondefault VRF is used to look up the HTTP server.

However, these changes are backward-compatible and do not aect existing behavior; meaning, you can still use the ip http source-

interface command to communicate with a particular interface even if no VRF is congured on that interface

NOTE: If the HTTP service is not VRF-aware, then it uses the global routing table to perform the look-up.

To enable an HTTP client to look up the VRF table corresponding to either management VRF or any nondefault VRF, use the ip http

vrf

command in CONFIGURATION mode.

• Congure an HTTP client with a VRF that is used to connect to the HTTP server.

CONFIGURATION MODE

Dell(conf)#ip http vrf {management | <vrf-name>}

Getting Started