Administrator Guide

!
interface GigabitEthernet 2/6
no ip address
shutdown
!
interface GigabitEthernet 2/7
no ip address
shutdown
!
interface GigabitEthernet 2/8
no ip address
shutdown
!
interface GigabitEthernet 2/9
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the
following steps:
1. View the configurations applied on an interface.
INTERFACE mode
show config
2. Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
3. Verify the configuration.
INTERFACE mode
show config
All the applied configurations are removed and the interface is set to the factory default state.
Enabling Energy Efficient Ethernet
Energy Efficient Ethernet (EEE) is an IEEE 802.3 az standard that reduces power consumptions on Ethernet ports. EEE stops
the transmission when there is no data to be transmitted and resumes the transmission at the arrival of new packets. You can
enable EEE only on one Gigabit and ten Gigabit native or optional module copper ports.
1. To enable EEE, use the eee command.
INTERFACE mode
Dell(conf)# interface gigabitethernet 1/1
Dell(conf-if-gi-1/1)# eee
2. To disable EEE, use the no eee command.
INTERFACE mode
Dell(conf)# interface gigabitethernet 1/1
Dell(conf-if-gi-1/1)# no eee
View EEE Information
To view the details of Energy Efficient Ethernet (EEE), you can use the following show commands.
You have several options for viewing the details of EEE on interfaces.
Interfaces
317