Users Guide
• Management Interfaces
• VLAN Interfaces
• Loopback Interfaces
• Null Interfaces
• Port Channel Interfaces
• Bulk Configuration
• Defining Interface Range Macros
• Monitoring and Maintaining Interfaces
• Link Dampening
• Link Bundle Monitoring
• Using Ethernet Pause Frames for Flow Control
• Configure the MTU Size on an Interface
• Port-Pipes
• Auto-Negotiation on Ethernet Interfaces
• Provisioning Combo Ports
• View Advanced Interface Information
• Configuring the Traffic Sampling Size Globally
• Dynamic Counters
Interface Types
The following table describes different interface types.
Table 22. Different Types of Interfaces
Interface Type Modes Possible Default Mode Requires Creation Default State
Physical L2, L3 Unset No Shutdown (disabled)
Management N/A N/A No No Shutdown (enabled)
Loopback L3 L3 Yes No Shutdown (enabled)
Null N/A N/A No Enabled
Port Channel L2, L3 L3 Yes Shutdown (disabled)
VLAN L2, L3 L2 Yes (except default)
L2 - Shutdown (disabled)
L3 - No Shutdown
(enabled)
Optional Modules
S3100 series supports an optional small form-factor pluggable plus (SFP+) or 10GBase-T module.
In S3100 series, the hot swap of optional modules is supported with the following behavior:
• If you change the same type of optional module, then the old configuration is retained.
• If you change a different type of optional module, then the optional module is moved into error state.
• You can modify the configuration of optional module interfaces, only if the optional module is present.
• After removing the optional module, you need to wait for the syslogs to be removed before inserting the optional module again. You
cannot insert the module immediately.
Interfaces
313