Users Guide

"NOT_REACHABLE: Syslog server
10.11.226.121 (port: 9140) is not reachable" SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 =
INTEGER: 2
Following is the sample audit log message that other syslog servers that are reachable receive:
Oct 21 00:46:13: dv-fedgov-s4810-6: %EVL-6-NOT_REACHABLE:Syslog server 10.11.226.121 (port:
9140) is not reachable
Following example shows the SNMP trap that is sent when connectivity to the syslog server is resumed:
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (10230) 0:01:42.30 SNMPv2-MIB::snmpTrapOID.
0 = OID: SNMPv2-
SMI::enterprises.6027.3.30.1.1.2 SNMPv2-SMI::enterprises.6027.3.30.1.1 = STRING:
"REACHABLE: Syslog server
10.11.226.121 (port: 9140) is reachable"SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 2
Following is the sample audit log message that other syslog servers that are reachable receive:
Oct 21 05:26:04: dv-fedgov-s4810-6: %EVL-6-REACHABLE:Syslog server 10.11.226.121 (port: 9140)
is reachable
Copy Configuration Files Using SNMP
To do the following, use SNMP from a remote client.
• copy the running-config file to the startup-config file
• copy configuration files from the Dell Networking system to a server
• copy configuration files from a server to the Dell Networking system
You can perform all of these tasks using IPv4 or IPv6 addresses. The examples in this section use IPv4 addresses; however, you can
substitute IPv6 addresses for the IPv4 addresses in all of the examples.
The following table lists the relevant MIBs for these functions are.
Table 76. MIB Objects for Copying Configuration Files via SNMP
MIB Object OID Object Values Description
copySrcFileType .1.3.6.1.4.1.6027.3.5.1.1.1.1.2
1 = Dell Networking OS file
2 = running-config
3 = startup-config
Specifies the type of file to copy
from. The range is:
• If copySrcFileType is
running-config or startup-
config, the default
copySrcFileLocation is flash.
• If copySrcFileType is a binary
file, you must also specify
copySrcFileLocation and
copySrcFileName.
copySrcFileLocation .1.3.6.1.4.1.6027.3.5.1.1.1.1.3
1 = flash
2 = slot0
3 = tftp
4 = ftp
5 = scp
6 = usbflash
Specifies the location of source
file.
• If copySrcFileLocation is FTP
or SCP, you must specify
copyServerAddress,
copyUserName, and
copyUserPassword.
copySrcFileName .1.3.6.1.4.1.6027.3.5.1.1.1.1.4 Path (if the file is not in the
current directory) and filename.
Specifies name of the file.
Simple Network Management Protocol (SNMP) 781