Administrator Guide

Use the keyword router to set the device role as router.
5. Set the hop count limit.
POLICY LIST CONFIGURATION mode
hop-limit {maximum | minimum limit}
The hop limit range is from 0 to 254.
6. Set the managed address configuration flag.
POLICY LIST CONFIGURATION mode
managed-config-flag {on | off}
7. Enable verification of the sender IPv6 address in inspected messages from the authorized device source access list.
POLICY LIST CONFIGURATION mode
match ra{ipv6-access-list name | ipv6-prefix-list name | mac-access-list name}
8. Enable verification of the advertised other configuration parameter.
POLICY LIST CONFIGURATION mode
other-config-flag {on | off}
9. Enable verification of the advertised default router preference value. The preference value must be less than or equal to the specified
limit.
POLICY LIST CONFIGURATION mode
router-preference maximum {high | low | medium}
10. Set the router lifetime.
POLICY LIST CONFIGURATION mode
router—lifetime value
The router lifetime range is from 0 to 9,000 seconds.
11. Apply the policy to trusted ports.
POLICY LIST CONFIGURATION mode
trusted-port
12. Set the maximum transmission unit (MTU) value.
POLICY LIST CONFIGURATION mode
mtu value
13. Set the advertised reachability time.
POLICY LIST CONFIGURATION mode
reachable—time value
The reachability time range is from 0 to 3,600,000 milliseconds.
14. Set the advertised retransmission time.
POLICY LIST CONFIGURATION mode
retrans—timer value
The retransmission time range is from 100 to 4,294,967,295 milliseconds.
15. Display the configurations applied on the RA guard policy mode.
POLICY LIST CONFIGURATION mode
show config
Example of the show config Command
DellEMC(conf-ra_guard_policy_list)#show config
!
ipv6 nd ra-guard policy test
device-role router
hop-limit maximum 251
mtu 1350
other-config-flag on
reachable-time 540
retrans-timer 101
router-preference maximum medium
trusted-port
DellEMC(conf-ra_guard_policy_list)#
IPv6 Routing
375