Administrator Guide

Configuring Storm Control from CONFIGURATION Mode
To configure storm control from CONFIGURATION mode, use the following command.
From CONFIGURATION mode you can configure storm control for ingress and egress traffic.
Do not apply per-virtual local area network (VLAN) quality of service (QoS) on an interface that has storm-control enabled (either on an
interface or globally).
• Configure storm control.
CONFIGURATION mode
• Configure the packets per second of broadcast traffic allowed in the network.
CONFIGURATION mode
storm-control broadcast packets_per_second in
• Configure the packets per second (pps) of multicast traffic allowed on C-Series and S-Series networks only.
CONFIGURATION mode
storm-control multicast packets_per_second in
• Configure the packets per second of unknown-unicast traffic allowed in or out of the network.
CONFIGURATION mode
storm-control unknown-unicast packets_per_second in
820 Storm Control