Administrator Guide

MIB Object OID Values Description
4 = le exists
5 = le not found
6 = timeout
7 = unknown
copyEntryRowStatus .1.3.6.1.4.1.6027.3.5.1.1.1.1.15 Row status Species the state of the copy
operation. Uses CreateAndGo
when you are performing the
copy. The state is set to active
when the copy is completed.
Obtaining a Value for MIB Objects
To obtain a value for any of the MIB objects, use the following command.
• Get a copy-cong MIB object value.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address [OID.index | mib-
object.index]
index: the index value used in the snmpset command used to complete the copy operation.
NOTE
: You can use the entire OID rather than the object name. Use the form: OID.index.
Examples of Getting MIB Object Values
The following examples show the snmpget command to obtain a MIB object value. These examples assume that:
• the server OS is UNIX
• you are using SNMP version 2c
• the community name is public
• the le f10-copy-cong.mib is in the current directory
NOTE
: In UNIX, enter the snmpset command for help using this command.
The following examples show the command syntax using MIB object names and the same command using the object OIDs. In both cases,
the same index number used in the snmpset command follows the object.
The following command shows how to get a MIB object value using the object name.
> snmpget -v 2c -c private -m ./f10-copy-config.mib 10.11.131.140 copyTimeCompleted.110
FTOS-COPY-CONFIG-MIB::copyTimeCompleted.110 = Timeticks: (1179831) 3:16:38.31
The following command shows how to get a MIB object value using OID.
> snmpget -v 2c -c private 10.11.131.140 .1.3.6.1.4.1.6027.3.5.1.1.1.1.13.110
SNMPv2-SMI::enterprises.6027.3.5.1.1.1.1.13.110 = Timeticks: (1179831) 3:16:38.31
860
Simple Network Management Protocol (SNMP)