Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1021

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

Usage Information By default, the dead interval is four times the default hello-interval.

Commands

• ip ospf hello-interval — set the time interval between the hello packets.

ip ospf hello-interval

Specify the time interval between the hello packets sent on the interface.

Syntax

ip ospf hello-interval seconds

To return to the default value, use the no ip ospf hello-interval command.

Parameters

seconds

Enter the number of seconds for the interval. The range is from 1 to 65535. The default is

10 seconds.

Defaults 10 seconds

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.