Administrator Guide

Version Description
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-Series.
7.7.1.0 Introduced on the E-Series.
Usage Information
When you configure a join filter, it is applicable for both ingress and egress flows. There is no option to specify in
or out parameters while configuring a join filter.
Example
DellEMC(conf)# ip access-list extended iptv-channels
DellEMC(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
DellEMC(config-ext-nacl)# permit ip any 232.1.1.0/24
DellEMC(config-ext-nacl)# permit ip 100.1.1.0/16 any
DellEMC(config-if-te-1/1)# ip pim join-filter iptv-channels
DellEMC(config-if-te-1/1)# ip pim join-filter iptv-channels
Related
Commands
• ip access-list extended — configure an access list based on IP addresses or protocols.
ip pim ingress-interface-map
When the Dell EMC Networking system is the RP, statically map potential incoming interfaces to (*,G) entries to create a lossless
multicast forwarding environment.
Syntax
ip pim ingress-interface-map std-access-list
Parameters
std-access-list Enter the name of a standard access list.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced
Example
DellEMC(conf)# ip access-list standard map1
DellEMC(config-std-nacl)# permit 224.0.0.1/24
1126 PIM-Sparse Mode (PIM-SM)