Administrator Guide
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
ping
Test connectivity between the system and another device by sending echo requests and waiting for replies.
Syntax
ping [host | ip-address | ipv6-address] [count {number | continuous}]
[datagram-size] [timeout] [source (ip src-ipv4-address) | interface] [tos] [df-
bit (y|n)] [validate-reply(y|n)] [outgoing-interface] [pattern pattern] [sweep-
min-size] [sweep-max-size] [sweep-interval] [ointerface (ip src-ipv4-address) |
interface] [ethernet | vrf vrf-name]
Parameters
host
(OPTIONAL) Enter the host name of the devices to which you are testing connectivity.
ip-address
(OPTIONAL) Enter the IPv4 address of the device to which you are testing connectivity.
The address must be in the dotted decimal format.
ipv6-address
(OPTIONAL) Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing
connectivity.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
count
Enter the number of echo packets to be sent. The default is 5.
• number: from 1 to 2147483647
• continuous: transmit echo request continuously
datagram size
Enter the ICMP datagram size. The range is from 36 to 15360 bytes. The default is 100.
timeout
Enter the interval to wait for an echo reply before timing out. The range is from 0 to 3600
seconds. The default is 2 seconds.
source
Enter the IPv4 or IPv6 source ip address or the source interface. For IPv6 addresses, you
may enter global addresses only. Enter the IP address in A.B.C.D format.
Control and Monitoring 113