Administrator Guide

Power over Ethernet (PoE)
DellEMC Networking OS supports Power over Ethernet (PoE) and Power over Ethernet Plus (PoE+) on S3100 series systems.
Use the commands in this chapter to configure the Power over Ethernet (PoE) on the S3100 platforms.
Topics:
• advertise dot3-tlv
• advertise med power-via-mdi
• power budget global-threshold
• power inline
• power inline legacy
• power inline mode
• power inline restore
• power inline suspend
• show power detail
• show power inline
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
S3100 series
Syntax
advertise dot3-tlv {max-frame-size | power-via-mdi}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-size | power-via-
mdi} command.
Parameters
max-frame-size Enter the keywords max-frame-size to advertise the dot3 maximum frame size TLV.
power-via-mdi Enter the keyword power—via-mdi to advertise IEEE 802.3 at power-via-mdi TLV.
Defaults None
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
41
Power over Ethernet (PoE) 1159